7.10.2021

Jim is putting panel pieces through the belt sander just to take off the final bit... 

Pieces in great shape!

Jim tried using his vibrating tool to take off the moulding...

He decided he could do a better job with the router...

Starting to do the first baseboard moulding inside the house!  First, he marks the top location on the wall...

Finding the studs...

Attaching the plywood backing board!

Jim is planning on using the Bobcat for some dirt work so he wanted to make sure it was in good shape - especially being sure that there was no sag on the tracks.  This requires jacking up the Bobcat.  The bottle jack he has is too tall so he bought this smaller one - it worked great.  He jacked it up and then put blocking underneath.  This first side was perfect - no sag.

Jacking up the other side...

This side had a slight sag - the way to correct that is to take off the access panels and put grease inside!  It took the sag out so he started buttoning it back up.

He did find another access panel on the bottom that was bent so he flattened that out...

At the end of the work day, he did the rest of the lawn mowing that got interrupted yesterday.  Time to get ready for church!

High 76/Low 56 - beautiful!