Jim got his next two cavities filled with insulation in the woodshop...he's over to the attic space door now so good progress being made.
He worked upstairs too...finished off this valley rafter area - he had to go back up into the attic space to finish this off.
This was one of those areas that Jim wasn't sure how he was going to insulate - it's the intersection between the kitchen wall and the closet wall. He needs to keep in mind ventilation in this area so it was complicated. He finally figured out how to cut and bevel rigid foam in to fit and stay supported.
After lunch, it was back up to work on the dormer wall.
Making good progress again...
Down to the last piece - which has to be a piece of HardiPlank because there's no way to attach shingles in the triangle area. Just figuring out this angle was tough!
Once Jim figured it out and tested it to make sure, he primed it up well. He'll paint it tomorrow and the last piece will be ready to go!
End-of-the-day picture!
After I left, Jim made a few of the trim pieces that will go underneath the eave.
 |
| High 76/Low 58 |
No comments:
Post a Comment