7.29.2019

Jim ordered some angle pieces from Albany Steel - they come very early in the morning so Jim was down there to take delivery.  He's going to use some of this to make a flat workspace for the Corian and some in the pole barn for more storage.

Jim's trimmer parts came in so he took the carburetor apart and then put things back together.

He made more custom flashing for the top of the stairwell overhang roof...

Working on installing the flashing...

The flashing is installed on both sides now.

He made the freeze board pieces that will go on top of the flashing on either side of the overhang roof.  He had to remember the techniques he used to install all these pieces - it's been a couple years now.  Unfortunately, he was out of the trim screws he needed - I'll pick those up tomorrow morning.

Since the overhang section is about done, Jim is getting ready for the next step - building the dormer on the stairwell roof.  He needs to set up another section of scaffolding...

However, the rest of the scaffolding pieces were nicely put away in our little shed.  Of course, they were small sections to the large ones so Jim had to take all the smaller sections out to get to the ones he needed.

Then he started building the sections...

He stopped on that project so he could use the newly-fixed trimmer for an hour or so before he called it a day.

High 89/Low 66