Jim started putting up the Z-flashing today. It's quite the project!
There is a piece of Z-flashing that has to fit between each of the panels on the roof. First step is to cut a special clay tape that gets attached to the roof...
Then the cut piece of flashing is put into place, and then Jim screws it down to the roof...
Doing a piece on the other side...
He made two wooden jigs for the different angles to mark where he needs to cut the end...
The main flashing pieces are all in place!
Jim has to figure out the bottom section, but just to make sure everything worked, he slipped on the hip trim. It's hemmed on both sides and has to intersect with the flashing pieces to keep everything waterproof...
You can see each of the individual flashing pieces from the underside and how it all works together...
 |
| High 79.6/Low 59.1 - beautiful! |
No comments:
Post a Comment