Always a lot of tool maintenance going on around here!
Starting the millwork on the desk top - the top tenon cut is done...
Doing the bottom cut. You can see that the boarder pieces are thicker - so Jim had to make the cuts differently - he made a rail for the top to ride on for the first cut with the table saw. Then he used his router to cut it out - but he still had to do some handwork on the transition.
A close up look...
Millwork done on both of the long borders...
It was such a tight fit - Jim had to get the hammer out to ensure it glued together correctly...
He also got more maple glued together for the medicine cabinet...
Fitting the top moulding piece on the shower...
Caulking the top...
A bead of caulk on the moulding...
Putting the moulding in place...
Taping it to hold it in place...
 |
| High 35.1/Low 9.1 |
No comments:
Post a Comment