Jim continued working around the woodshop, filling in another 2 cavities. Actually there was a stud in the middle of the last cavity so he had to cut the batts down the middle so a bit tougher.
He got the fiberglass in the valley rafter area in the kitchen - these require getting up in the attic so they are nice to have done.
Plus the master bedroom wall is all complete with a couple cavities redone.
Besides painting the day's batch of cut shingles, he made the corner eave trim piece.
Then it was time to install the siding pieces...
So very many cuts - Jim went up and down the scaffolding all day!
Making good progress...
This is as far as Jim could work today on this section - tomorrow morning, he'll paint the gray on the remaining bottom angle pieces that he cut and I primed today.
So then he moved down and started working on getting ready to install the freeze board. First he has to put up a spacer and then a starter piece.
Then the freeze board can go up...
The finished product - looks great!
End-of-the-day picture...
 |
| High 78/Low 60 |
No comments:
Post a Comment